Ice Maker Repair in Falls Church, VA
No ice, slow production, or leaks in built-in units. Our specialist technicians serve Falls Church, VA with same-day appointments, upfront pricing, and a 90-day warranty on every repair.

Your Local Ice Maker Repair Team in Falls Church
In the heart of "The Little City" and Lake Barcroft, we deliver quick, reliable appliance repair without the wait.
We proudly serve Falls Church neighborhoods including The Little City, Seven Corners, West Falls Church, Lake Barcroft — usually with same-day availability.
Why an Ice Maker Stops Making Ice
Most ice maker faults trace to water supply or the ice-making module, not the whole appliance. Here is how we sort them out in Falls Church.
- No ice at all
- The water inlet valve, a frozen fill tube, or a failed ice maker module. We test the valve and the module's heater and motor separately so only the failed part is replaced.
- Small, hollow, or cloudy cubes
- Low water pressure or a clogged filter or valve screen. Often a quick fix once the flow is measured.
- Water leaking near the ice maker
- A cracked fill tube, loose line fitting, or a drain problem on an undercounter unit.
- Ice tastes or smells off
- A saturated water filter or stale ice sitting in the bin. Cleaning the bin and replacing the filter resolves most cases.
- Unit freezing up into a solid block
- A stuck water valve or a faulty temperature sensor lets water keep flowing after the cycle should stop.
- Ice maker runs but the bin stays empty
- Usually a jammed ejector arm or a bail-arm switch that is not registering.
We schedule ice maker visits across The Little City, Seven Corners, West Falls Church and the rest of Falls Church.
Common Ice Maker Problems We Fix in Falls Church
Something else? We fix it all in Falls Church. Call (571) 571-1664
Why Falls Church Homeowners Choose Commonwealth
Same-Day Service
Fast appointments across Falls Church, 7 days a week.
A Local Team That Answers
Real local specialists you can reach — not a call center.
90-Day Warranty
Parts and labor on every repair are covered for 90 days from the service date, in writing on your invoice.
Upfront Pricing
You approve the price before any work begins.
Ice Maker Repair in Falls Church — FAQ
Do you offer same-day ice maker repair in Falls Church?+
Yes. We offer same-day and next-day ice maker repair throughout Falls Church, VA whenever our schedule allows. Call early in the day for the best chance of a same-day visit.
How much does ice maker repair cost in Falls Church?+
We diagnose the problem and give you a firm, upfront price before any work begins — no surprises. Every repair in Falls Church is backed by our 90-day parts and labor warranty.
Do you repair luxury ice maker brands in Falls Church?+
Absolutely. High-end appliances are our specialty in Falls Church — we service Sub-Zero, Wolf, Viking, Thermador, Miele, Bosch, and every other major brand.
Do you install new ice makers in Falls Church?+
No. We repair existing appliances only — we don't sell or install new units. If a repair doesn't make financial sense, we'll tell you so honestly.
How quickly can you respond to Falls Church for appliance repair?+
Falls Church is one of our closest Northern Virginia service areas — we can typically reach most Falls Church addresses, in both the City of Falls Church and the surrounding Fairfax County communities, within an hour of scheduling. We offer same-day appointments whenever our schedule allows.
How to Diagnose an Ice Maker Problem Before Calling
Run through these checks in Falls Church before calling — you may save a service visit.
- 1
Check that the ice maker arm or switch is set to ON
Many ice makers have a wire arm or a wall switch that pauses production when ice is full — or gets accidentally bumped. Confirm it's in the down (ON) position.
- 2
Verify the water supply line is open and pressurized
The supply shutoff valve (usually behind the refrigerator or under the sink) must be fully open. Low pressure — below 20 PSI — causes the ice maker to produce hollow or crescent-shaped cubes, or none at all.
- 3
Inspect the inlet valve screen for mineral buildup
Hard water deposits clog the small screen on the water inlet valve. Turn off the supply, remove the valve line, and rinse the screen under running water.
- 4
Check for ice jams in the bin or auger
A cluster of fused cubes can jam the ejector arm or auger motor. Empty the bin, clear any clumps, and run a harvest cycle (usually a test button on the ice maker module).
- 5
Call a technician if the ice maker leaks or the module is unresponsive
Water pooling under or inside the refrigerator, or an ice maker that ignores the test button, indicates a failed module, inlet valve, or ice mold heater — all require professional service.
Still having trouble? Call (571) 571-1664 for same-day ice maker repair in Falls Church.
Want to diagnose it first? See our common-symptom troubleshooting guide →
Ice Maker Repair Near Falls Church
Other Repairs in Falls Church
Need ice maker repair in Falls Church today?
Same-day appointments across Falls Church, VA. Call for the fastest response, or fill out the form and we'll call you right back.
Call (571) 571-1664
